Titanium Tools and Equipment Inc

For easy puller, easy puller II, and the pet slide hammers.

Straight keys can be welded very close together so are ideal for strong pulls on rockers. Weld keys according to the strength of pull required. The...

Twisted keys are ideal for press lines and curved areas like gas tanks. Weld keys according to the strength of pull required. Can be welded with mi...

The carbon rod allows you to heat up the metal panel without leaving the job to get a torch. The heat can be controlled by touching the metal surfa...

Miracle aluminum bit straight type with Lines. The lines allow you to cut the key at the correct length for even pulls.

The point shrinking tip allows you to put down high spots and shrink where required often allowing you to remove “oil canning” without burning the ...

The bit holder allows you to hold all three key types and attach them to the panel. MB-1, MB-2 and MB-3 fit in the slot and hold the key tightly.

Easy puller hook for aluminum bits MAB-PA and MAB-PSP.

This high tef oil is great for lubricating the cable that attaches to Easy Puller I and II for smooth operation and less wear of the clips and tool...

It is a replacement special bit for the Easy Puller III.

These washers can be welded with minimum electric current, resulting in very little damage to the panel Can be used for strong places like; quarte...

The spot welding tip allows you to tack thin patches for repair quickly and easily prior to MIG welding.

The roll patching tip allows you to repair small torn areas on a panel quickly and easily.

Rubber head cover only, hammer not included. To be used with Miracle Hammer Rubber Face Horizontal Peen (MHSG-03) and Miracle Hammer Rubber Face Ve...

Miracle Special Aluminum Bit Straight Type with Lines.

Miracle Special Aluminum Bit Screw Type with Lines.

Miracle Special Aluminum Bit for Easy Puller.

This aluminum bit can be used with the easy puller for small dents. The round hole works with the limited travel of the easy puller.

This aluminum bit is used for body lines. The lines allow you to cut the key at the correct length for even pulls.

This tip is to be used in the steel welder (SMS-7Q) for shrinking aluminum. The MS-U-B17 heats up and can be used to shrink aluminum panels. Techni...

It replaces the standard lever puller hook with this hook for pulling on individual aluminum bits.