Miracle System Steel Consumables

These washers can be welded with minimum electric current, resulting in very little damage to the panel Can be used for strong places like; quarte...

Straight keys can be welded very close together so are ideal for strong pulls on rockers. Weld keys according to the strength of pull required. The...

Twisted keys are ideal for press lines and curved areas like gas tanks. Weld keys according to the strength of pull required. Can be welded with mi...

The bit holder allows you to hold all three key types and attach them to the panel. MB-1, MB-2 and MB-3 fit in the slot and hold the key tightly.

The point shrinking tip allows you to put down high spots and shrink where required often allowing you to remove “oil canning” without burning the ...

The roll patching tip allows you to repair small torn areas on a panel quickly and easily.

The carbon rod allows you to heat up the metal panel without leaving the job to get a torch. The heat can be controlled by touching the metal surfa...

The spot welding tip allows you to tack thin patches for repair quickly and easily prior to MIG welding.

Stud weld and dent pull like a pro with the Miracle Multi-Earth Ground Clamp. Key Features A wider grounding area with a welding tip increases out...

The special Miracle system ground. It can replace the ground on older models or new models. The ground has 3 ways of attaching to the panel. The t...

Used with shrink tube to repair the Miracle ground clamp, MME-00.

Used with brass pipe to repair the Miracle ground clamp, MME-00.

Replacement ground bit for Miracle ground clamp.

This is the attachment cables for attaching easy puller I and II to the welding machine. It has 2 clips allowing the welding attachment to stay in ...

This is the attachment cable for attaching Easy Puller I and II to the welding machine. It has 1 clip and one Pin. The Pin inserts in to the end of...

Rubber head cover only, hammer not included. To be used with Miracle Hammer Rubber Face Horizontal Peen (MHSG-03) and Miracle Hammer Rubber Face Ve...

For easy puller, easy puller II, and the pet slide hammers.

It is a replacement special bit for the Easy Puller III.

This high tef oil is great for lubricating the cable that attaches to Easy Puller I and II for smooth operation and less wear of the clips and tool...

Replacement small circle frame for the Miracle System Easy Puller III and Easy Puller 10Z.

Replacement Handle for the Miracle System Easy Puller 10Z.

Replacement Center Shaft for the Miracle System Easy Puller 10Z.

Replacement magnet for Miracle ground clamp.