This 120-volt, 550-watt hot air heating element is designed for use with Polyvance's 6000 series, 8000 series, and 8200 series nitrogen plastic welders. This is NOT compatible with the 8300 series Nitro-Fuzer Touch.

How to Test the Element:

To test your element, you will need a multimeter.

Ohms setting: Set your multi-meter to the Ohms setting. Touch the brass ends of the element with the leads of the multimeter.

• You will get a reading of 26.2 ohms (± 1 ohm) if the element is GOOD.
• You will get a reading of 0 if the element is BAD.

Continuity setting: Set your multimeter to the "Continuity" setting. Touch the metal ends of the element with the leads of the multimeter.

• You will get a reading of 0 if the element is GOOD. Some multimeters beep when there is continuity. If your multimeter beeps, then the element is GOOD.
• You will get a reading of 1 if the element is BAD. Some multimeters beep when there is continuity. If your multi-meter does NOT beep, then the element is BAD.